NOTE: Information displayed from the commands below can be used to fill in the Vendor Platform Validation form.
Devices
- Boot from the installation CD/DVD.
- At the first screen (Welcome to OpenXT Installer), press Alt-F3
- At the prompt, type root and press enter.
...
a) During the above and below steps and during the actual install, note any issues with keyboard functionality.
2.2) All Hard Drives hard drives visible.
a) At the prompt, type fdisk -l and press enter.
b) Verify and note the disk(s) have been identified by the system and the size(s) of the disk(s) are correct.
2.3) All optical media drives are visible.
a) At the prompt, type cat /proc/sys/dev/cdrom/info
...
i) Information about the CD/DVD device(s) is displayed.
2.4) All network cards /ports are visible.
a) At the prompt, type lspci -v | grep -iE 'Wire|Ether' and press enter.
i) Information about the Network Interface Cards is displayed.
...
d) Configure the BIOS for successful measured launch (and PXE boot if applicable).
NOTE: This should have been accomplished in Section 1: BIOS Configuration.
e) Boot from the OpenXT DVD.
...
NOTE: This is based on the system being cleard cleared and appropriate settings enabled/disabled in the BIOS (Section 1: BIOS Configuration)
2.9) Installer completes.
2.10) System reboots into UIVM.
Network installation
2.11) System boots to PXE or other netboot server
...
2.12) OpenXT installer starts.
2.13) Installer pulls repository from the network network.
2.14) Installer passes system checks.
2.15) Installer passes measured launch checks.
NOTE: This is based on the system being cleard cleared and appropriate settings enabled/disabled in the BIOS (Section 1: BIOS Configuration)
2.16) Installer completes.
2.17) System reboots into UIVM